Cudy AP3000 Indoor AKA Jupiter 2 and OpenWRT: Difference between revisions
| Line 12: | Line 12: | ||
No details here on what is needed for that as there is plenty of information out there. This website has some pictures: https://eko.one.pl/forum/viewtopic.php?id=24096 Oh, and great spot for the vias to solder in some pins, right? Well good news is that there is lots of space if one solders the pins on the backside of the PCB. | No details here on what is needed for that as there is plenty of information out there. This website has some pictures: https://eko.one.pl/forum/viewtopic.php?id=24096 Oh, and great spot for the vias to solder in some pins, right? Well good news is that there is lots of space if one solders the pins on the backside of the PCB. | ||
== Pins / Holes for Serial / TTY == | |||
Here's another really cool thing. The Pin Headers for the TTY / Serial communication are covered by a heat sink (on the top of the PCB) and a base plate (on the bottom of the PCB). It has been noticed that there is a minor design difference on some models where the Header Pin Holes on some models are visible because of a smaller base plate. Others have a base plate that covers the holes. | |||
The Header Pin Holes from the bottom, labeled from the edge of the PCB closest to the holes or just look at the picture of the top of the PCB with the Header Pin Holes labeled with a screen printing. | |||
[[File:Cudy AP3000 (Indoor Jupiter 2) TTY Serial Headers Bottom with Header Clips.jpg|alt=Cudy AP3000 (Indoor Jupiter 2) TTY Serial Headers Bottom with Header Clips|left|thumb|Cudy AP3000 (Indoor Jupiter 2) TTY Serial Headers Bottom with Header Clips]] | |||
<br /> | |||
* VCC / 3.3 Volts + | |||
* GND / Negative | |||
* RX | |||
* TX (the square solder pad) | |||
<br /> | |||
==Hardware Setup== | ==Hardware Setup== | ||
| Line 100: | Line 113: | ||
*Do not load images to `0x48000000` if that is also the decompress target. | *Do not load images to `0x48000000` if that is also the decompress target. | ||
*To make this repeatable, avoid saving `bootcmd` unless a custom autoboot is configured. | *To make this repeatable, avoid saving `bootcmd` unless a custom autoboot is configured. | ||
<br /> | |||
[[File:Cudy AP3000 (Indoor Jupiter 2) TTY Serial Headers.jpg|alt=Cudy AP3000 (Indoor Jupiter 2) TTY Serial Headers|center|thumb|Cudy AP3000 (Indoor Jupiter 2) TTY Serial Headers]] | |||
<br /> | |||