Cudy AP3000 Indoor AKA Jupiter 2 and OpenWRT: Difference between revisions
m →Notes |
|||
| Line 26: | Line 26: | ||
Oh, and notice the little "PCB Test Clips" / "Test Points" / "Through Hole Loops" (various names they're referred to as). No solder needed, works great. Why not just solder in some pins? Remember, if you've got a model that has the bigger base plate, they'll need to be unsoldered too. Clip Leads? In the middle of the board. Difficult if not impossible. Some spring "grabber" style might work if there's something on the other side to grab onto. | Oh, and notice the little "PCB Test Clips" / "Test Points" / "Through Hole Loops" (various names they're referred to as). No solder needed, works great. Why not just solder in some pins? Remember, if you've got a model that has the bigger base plate, they'll need to be unsoldered too. Clip Leads? In the middle of the board. Difficult if not impossible. Some spring "grabber" style might work if there's something on the other side to grab onto. | ||
* https://www.amazon.com/dp/B0BC6CBDYY?ref_=ppx_hzsearch_conn_dt_b_fed_asin_title_2 (thankfully out of stock as of the writing of this) | *https://www.amazon.com/dp/B0BC6CBDYY?ref_=ppx_hzsearch_conn_dt_b_fed_asin_title_2 (thankfully out of stock as of the writing of this) | ||
* https://www.ebay.com/itm/324836665545 (for bigger holes, not these, just noting this one so it is known there are different sizes)<br />And don't forget, it'll probably be wiser to do all of this from the bottom and gently screw the heatsink back in place over the SoCs so nothing melts while the upgrade is taking place. | *https://www.ebay.com/itm/324836665545 (for bigger holes, not these, just noting this one so it is known there are different sizes)<br />And don't forget, it'll probably be wiser to do all of this from the bottom and gently screw the heatsink back in place over the SoCs so nothing melts while the upgrade is taking place. | ||
==Hardware Setup== | ==Hardware Setup== | ||
| Line 118: | Line 118: | ||
*To make this repeatable, avoid saving `bootcmd` unless a custom autoboot is configured. | *To make this repeatable, avoid saving `bootcmd` unless a custom autoboot is configured. | ||
== Pin Hole Headers (top of PCB with edge closest to the holes at the top) == | |||
[[File:Cudy AP3000 (Indoor Jupiter 2) TTY Serial Headers.jpg|alt=Cudy AP3000 (Indoor Jupiter 2) TTY Serial Headers|center|thumb|Cudy AP3000 (Indoor Jupiter 2) TTY Serial Headers]] | [[File:Cudy AP3000 (Indoor Jupiter 2) TTY Serial Headers.jpg|alt=Cudy AP3000 (Indoor Jupiter 2) TTY Serial Headers|center|thumb|Cudy AP3000 (Indoor Jupiter 2) TTY Serial Headers]] | ||
<br /> | <br /> | ||