OpenWRT x86 Style Disks and Booting

For this experiment EXT 4 will be used (as opposed to SquashFS).

Copy the MBR and "MBR Gap" (GRUB Stage 1, GRUB Stage 1.5 (containing the CORE.IMG file)): dd if=/dev/sdX of=/dev/sdY bs=512 count=511

Breaking it down into two steps, see below (but watch out, because for some reason DD doesn't seem to do something right regardless of the order the below are done);
Copy the "MBR Gap" (GRUB Stage 1.5, containing the CORE.IMG file): dd if=/dev/sdX of=/dev/sdY bs=512 skip=1 count=511
Copy the MBR (GRUB Stage 1 and Partition Table): dd if=/dev/sdX of=/dev/sdY bs=512 count=1

Copy the First Partition (/boot Directory): dd if=/dev/sdX1 of=/dev/sdY1 bs=128M conv=noerror progress=status

Copy the Second Partition (/root equivalent): dd if=/dev/sdX2 of=/dev/sdY2 bs=128M conv=noerror progress=status

Flush any buffered information to disk: sync

Syntax Notes;

if: Input File (or Device)
of: Output File (or Device)
bs: "How much to copy from one device to another at a time"
conv=noerror: "Don't stop, just do what I told you to do, and don't give an excuse"
progress = status: Show the progress of the copy process (only for a certain version of DD and up)
sync: Write all buffered blocks to disk (just to be safe)

Other Notes

Copying the MBR and MBR Gap can be combined into a single step (it was done to clarify and make an explicit point that there is important code stored in the MBR Gap necessary to boot OpenWRT with GRUB): dd if=/dev/sdX of=/dev/sdY bs=512 count=512. And for some reason, doing the MBR Gap first, messes up the MBR. Not a clue why.
The "MBR Gap" for OpenWRT's x86 "flavor" is 511 Sectors (Sectors 2 - 511, 512 is the beginning of the first partition, AKA /boot Partition). That's just how it is for OpenWRT because it is what they decided. And just as a historical note, the "MBR Gap" is almost twice as big as the entire capacity of a Commodore 1541 disk (single sided is 170K). And don't think OpenWRT is being wasteful of space either. If one uses CFDISK (or equivalent), the MBR GAP is 2048 Sectors (4 times that of OpenWRT, still 512 Bytes per Sector).
If conv=sync is used an out of space error will occur.

Copy the MBR, "MBR Gap", and First Partition ( /boot Directory ) per the "Cloning a Drive" Section
Edit the /boot/grub/grub.cfg file, changing portion of the menuentry, from rootfstype=squashfs to rootfstype=ext4
Format the Second Partition: mkfs.ext4 -L WhatEverName -v /dev/sda2 (-L = Label (can be named ROOT for clarity), -v = Verbose)
Resize the Second Partition (if cloned from a "Virgin OpenWRT" install) to a larger size using GParted or CFDISK (16 GB is more than enough)

Tips;

Use GParted to Locate Mount Points and to resize Partitions (if using a Live Rocky Linux, CentOS, etc. USB Based , the mount points for Rocky Linux, etc, end up in /run/media/root/WhatEverMountPoint by default.

Navigation menu